Universal Electronics MILLENNIUMTM 3 Guide de l'utilisateur télécharger pdf (Page 23)

CHECKING THE CODES

If you have set up the Millennium 3 using the Searching

For Your Code procedure,you may need to find out which

four-digit code is operating your equipment:

For example,to find out which code is operating your TV:

1. Turn on your TV.

2. On the Millennium 3,press and hold SETUP

until the LED blinks twice,then release SETUP.

3. Enter 9- 9 - 0.The LED will blink twice.

4. To view the code for the first digit,press 1once.

Wait 3 seconds and count the number of LED

blinks (e.g.,3 blinks = 3) and write down the

number in the leftmost TV Code box below.

NOTE: If a code digit is “0”,the LED will not blink.

5. Repeat step 4 three more times for remaining

digits.Use 2 for the second digit,3for the third

digit,and 4for the fourth digit.Finish writing

down the code in the TV Code boxes below.

6. To check for the codes of other components,

repeat steps 1 through 5,but substitute the

appropriate key (i.e.,VCRor CBL) for the (VCR

or Cable) component you are checking.Write

down the codes in the appropriate boxes below.

TV Code

VCR Code

CABLE Code

Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Universal Electronics MILLENNIUMTM 3 Guide de l'utilisateur Page 23