Universal Electronics DVR/PVR 5 Manuel d'utilisateur télécharger pdf (Page 26)

PROGRAMMING CHANNEL CONTROL LOCK

By default,the remote control’s channel-control capabilities

are locked to the cable converter. The affected keys* are

0~9,CH+,CH-,ENTER,and LAST.This will guarantee that

you do not inadvertently change a channel on your TV or

VCR.However,you can de-activate this feature to allow full

access to these keys in the TV and VCR modes.

*NOTE: This feature does not affect the AUD mode.

To De-Activate Channel Control Lock:

1. On the remote control,press CBL once; it will

blink once.Then press and hold SETUP until

the CBL key blinks twice,then release SETUP.

2. Enter 9-7- 3.The CBL key will blink twice.

3. Press CH- once. The CBL key will blink

four times.

4. Now,the remote control will provide TV and

VCR channel-control capabilities while in the

TV or VCR mode.

To Re-Activate Channel Control Lock:

1. On the remote control,press CBL once; it will

blink once.Then press and hold SETUP until

the CBL key blinks twice,then release SETUP.

2. Enter 9-7- 3.The CBL key will blink twice.

3. Press CH+ once. The CBL key will blink twice.

4. Now,regardless of what mode you select

(except AUD),only the channel control

capability of your cable converter will be

accessible.

Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Universal Electronics DVR/PVR 5 Manuel d'utilisateur Page 26