Universal Electronics Millenium 4 Manuel d'utilisateur télécharger pdf (Page 39)

CHECKING THE CODES

If you have set up the Millennium 4 using the

Searching For Your Code procedure, you may need

to find out which four-digit code is operating your

equipment:

For example, to find out which code is operating

your TV:

1. Turn on your TV.

On the Millennium 4, press and hold

SETUP until the LED blinks twice, then

release SETUP.

3. Enter 9 - 9 - 0. The LED will blink twice.

To view the code for the first digit, press

1 once. Wait 3 seconds and count the

number of LED blinks (e.g., 3 blinks =-3)

and write down the number in the left-

most TV Code box below.

NOTE: If a code digit is “0”, the LED will not

blink.

5. Repeat step 4 three more times for

remainingdigits. Use 2 for the second

digit, 3 for the third digit, and 4 for the

fourth digit. Finish writing down the

code in the TV Code boxes below.

6. To check for the codes of your other

components, repeat steps 1 through 5,

but substitute the appropriate key (i.e.,

VCR or AUDIO) for the (VCR, or Audio)

component you are checking. Write

down the codes in the appropriate boxes

below.

TV Code

VCR Code

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Universal Electronics Millenium 4 Manuel d'utilisateur Page 39