Universal Electronics Thermostat 975 Manuel d'utilisateur télécharger pdf (Page 9)

Installation

Insert the wires into the terminals on

the base using the appropriate

wiring diagram and tighten the

terminal screws.

CONFIGURINGCONFIGURING

CONFIGURING

AND PROGRAMMINGAND PROGRAMMING

AND PROGRAMMING

Before the power is turned on, the

thermostat must be configured to

operate properly with the system.

See the CONFIGURATION section

of this manual.

This thermostat can be programmed

for automatic temperature control.

Refer to Operating Instructions for

programming.

Figure 1. Thermostat base and terminalsFigure 1. Thermostat base and terminals

Figure 1. Thermostat base and terminals

Mounting screws

Pull wires through this opening

Insert wires into terminal holes, then tighten screws

Screw anchors

MVWRHRCGYOB6

S1 S2 S3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Pas de commentaire

Universal Electronics Thermostat 975 Manuel d'utilisateur Page 9