Universal-electronics Atlas 4-DEVICE Universal Remote Control Manuel d'utilisateur télécharger pdf (Page 28)

CHANGING VOLUME LOCK

On the Atlas Universal Remote Control,Global Volume Lock

is set to TV, so you can control TV volume while in the TV,

VCR,or Cable mode.If desired,you can still perform

Individual Volume Unlock on a selected device to set its

volume control for independent operation.

NOTE: If you lock the volume controls to the AUDIO mode, you will

still have control of the audio device’s volume in all other modes

(i.e., TV,VCR,and CBL).

To Unlock Volume Control For A Single Device

(Individual Volume Unlock):

1. Assuming Global Volume Lock is active, select a

mode on the remote control that you want to

unlock (e.g.,CBL) and press it once. Next, press

and hold SETUP until the device key blinks

twice, then release SETUP.

2. Enter 9 - 9 - 3.

3. Press VOL– once. The selected device key (in

step 1) will blink four times.

4. Repeat steps 1 through 3 (of this section) for

each device you want volume to be unlocked.

5. Now, after you select a device that has volume

unlocked (e.g.,CBL), pressing VOL+, VOL–,or

MUTE, will control the device’s volume only in

its own mode.

To Unlock All Volume Control (Global Volume

Unlock):

NOTE: Performing these instructions will set independent volume

control for all programmed devices (e.g., TV volume control in

TV mode,VCR volume in VCR mode, etc.).

1. On the remote control,press and hold SETUP

until the last-selected device key blinks twice,

then release SETUP.

2. Enter 9 - 9 - 3.

3. Press VOL+ once. The last-selected device key

(in step 1) will blink four times.

Atlas Manual 4/8/02 9:37 AM Page 28

1 2 ... 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Universal-electronics Atlas 4-DEVICE Universal Remote Control Manuel d'utilisateur Page 28