Universal-electronics URC-1047 Manuel d'utilisateur télécharger pdf (Page 14)

USING THE MASTER POWER KEY

The URC-1047 Universal Remote Control has a unique

feature that allows you to sequentially turn on or off up to

four of your home entertainment devices with a single

key press.

NOTE: MASTER POWER requires programming and only works in

the CBL mode. If it is not programmed, only the cable converter

will turn on or off. In any other mode, pressing MASTER POWER

once will turn on or off the selected device.

To Program The Master Power Key:

1. On the remote control,press and hold SETUP

until the last-selected device key blinks twice,

then release SETUP.

2. Enter 9 - 9 - 5.The last-selected device key

will blink twice. Then press POWER once.

3. For the first device you want in the power on

sequence, press a device key (e.g.,TV) once

and then press POWER once.

4. Repeat step 3 up to three more times to add the

second,third,and fourth device,as desired.

5. To save the settings and exit the program,press

CBL once.Next, press and hold SETUP until

the CBL key blinks twice, then release SETUP.

To Operate The Master Power Key:

1. After programming, point the remote control

at the devices. Press CBL once.

2. Press MASTER POWER once to sequentially

turn on or off all home entertainment devices.

3. You will see the devices turn on or off

according to the programmed sequence.

To Clear The Master Power Key:

1. Perform steps 1 and 2 in the first section

above, To Program The Master Power Key.

2. To clear the settings and exit the program,

press and hold SETUP until the CBL key blinks

twice, then release SETUP.

Time Warner Houston Manual 11/20/02 3:54 PM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Pas de commentaire

Universal-electronics URC-1047 Manuel d'utilisateur Page 14