Universal-electronics URC-1047 Manuel d'utilisateur télécharger pdf (Page 8)

PROGRAMMING DEVICE CONTROL

The URC-1047 Universal Remote Control is preprogrammed

to operate a Motorola interactive digital terminal,an RCA

TV, an RCA VCR, and a Pioneer audio receiver.

To control devices other than the default brands,perform

the following steps; otherwise skip this section:

NOTES: To control a DVD player, program the VCR key. To control

a PVR, program the VCR key. To control a stereo amplifier or

receiver, program the AUD key. For TV/VCR Combo control, skip

this section and perform the instructions on page 10.

1. Turn on a device and, if applicable,insert

video media, (e.g., cassette or disc).

NOTE: Please read steps 2 through 4 completely

before proceeding. Highlight or write down the codes

and device you wish to program before moving on to

step 2.

2. On the remote control,press a device key once

(e.g., AUD,VCR,or TV). Press and hold

SETUP until the selected mode key blinks

twice, then release SETUP.

3. Use the Manufacturer’s Codes (starting on

page 38) to locate the the type of device and

brand name and then enter the first four-digit

code for your device.If performed correctly,

the selected mode key will blink twice.

NOTE: If the selected mode key emits a long blink,

the entry is invalid. Repeat steps 2 through 3 and try

entering the same code again.

4. Aim the remote control at the device and

press POWER once. The device should turn

off. If it does not,repeat steps 2 through 3,

trying each code for your brand until you

find one that works. If it still does not

respond, try searching for the code (see

Searching For Your Code on page 11).

NOTE: If the device does not have a POWER key,

press the (Play) key.

Time Warner Houston Manual 11/20/02 3:54 PM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Pas de commentaire

Universal-electronics URC-1047 Manuel d'utilisateur Page 8