Universal Electronics CONTROL 2 Manuel d'utilisateur télécharger pdf (Page 12)

www.urcsupport.com/atlasocap

NOTE: If the VCR key did not blink twice after enter-

ing the codes last digit, repeat steps 2 through

3 and try entering the same code again.

If you’ve located a setup code that works for

your combo device (for example, a TV/VCR

Combo) and a separate TV code is also listed,

you’ll need to program this code into the

remote control to access volume control (see

“Programming Device Control” starting on

page 10).

5. For future reference, write down each working

device code in the boxes below:

TV/VCR or TV/DVD Code

TV Code (if used)

SEARCHING FOR YOUR CODE

If your home entertainment device does not respond to

the Atlas OCAP 5-Device Remote Control after trying all

of the codes listed for your brand, or if your brand is not

listed at all, try searching for your code.

For example, to search for a code for your TV:

1. Turn on your TV.

4. Aim the remote control at your combo device

(for example, TV/VCR Combo) and press

PWR once. The device should turn off. If it

does not respond, repeat steps 2 through 3,

trying each code listed for your brand until

you find one that works. If it still does not

respond, try searching for the code

(“Searching for Your Code” starting on

page 12).

2. On the remote control, press TV once; it will

blink once. Then press and hold SETUP until

the TV key blinks twice.

3. Enter 9 9 1. The TV key will blink twice.

4. Aim the remote control at the TV and press

PWR once.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 87 88

Pas de commentaire

Universal Electronics CONTROL 2 Manuel d'utilisateur Page 12