Universal Electronics CONTROL 2 Guide de l'utilisateur télécharger pdf (Page 22)

PROGRAMMING ID LOCK

The Atlas Universal Remote Control is preprogrammed

and locked at the factory to operate a Scientific Atlanta

cable converter.

However, if you have another brand or model of cable

converter and interactive service that you would like to

control, then you’ll need to perform the following steps to

unlock the cable ID Lock,enter in a new manufacturer’s

code, and lock the ID Lock again.

1. Turn on the cable converter.

2. On the remote control,press CBL once.

Then press and hold SETUP until the

CBL key blinks twice, then release SETUP.

3. Enter 9 - 8 - 2.The CBL key will blink

four times.

4. Perform the instructions in Programming

Device Control on page 8 to program device

control for the desired cable converter and

interactive service. Upon completion, perform

the remaining steps (5 and 6 on this page) to

again lock the ID lock.

5. On the remote control,press CBL once.

Then press and hold SETUP until the

CBL key blinks twice, then release SETUP.

6. Enter 9 - 8 - 2.The CBL key will blink twice.

Atlas Manual rev2 12/27/02 11:07 AM Page 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Pas de commentaire

Universal Electronics CONTROL 2 Guide de l'utilisateur Page 22