Universal Electronics CONTROL 2 Guide de l'utilisateur télécharger pdf (Page 30)

TROUBLESHOOTING

PROBLEM: Mode key does not blink when you press a key.

SOLUTION: Replace the batteries with two (2) new AA

alkaline batteries (see page 7).

PROBLEM: Mode key blinks when you press a key,but home

entertainment device does not respond.

SOLUTION: Make sure you are aiming the remote control at

your home entertainment device and that you

are within 15 feet of the device you are trying

to control.

PROBLEM: The remote control does not control home

entertainment devices or commands are not

performing properly.

SOLUTION: Try all listed codes for the device brand being set

up. Make sure all devices can be operated with

an infrared remote control.

PROBLEM: TV/VCR combo does not respond properly.

SOLUTION: Use the VCR codes for your brand. Some combo

units may require both a TV code and a VCR

code for full operation (see page 9).

PROBLEM: No volume on a second TV.

SOLUTION: Follow instructions in Changing Volume Lock

(see page 28).

PROBLEM: CH+ , CH – ,and LAST do not work for your

RCA TV.

SOLUTION: Due to RCA design (1983-1987), only the original

remote control will operate these functions.

PROBLEM: Changing channels does not work properly.

SOLUTION: If original remote control required pressing

ENTER to change channels, press ENTER on the

remote control after entering a channel number.

PROBLEM: Tried “Search Method”and still could not find a

working code.

SOLUTION: Try the “Search Method”again after clearing out

the device key as follows: Press and hold SETUP

until mode key blinks twice, then release. Next

enter 9 - 9 - 2. Then press and release the mode

key to be cleared twice.

PROBLEM: Remote control does not turn on Sony or Sharp

TV/VCR Combo.

SOLUTION: For power on, these products require program-

ming TV codes on the remote control. For Sony,

use TV code 0000 and VCR code 0032. For Sharp,

use TV code 0093 and VCR code 0048.

Atlas Manual rev2 12/27/02 11:08 AM Page 30

1 2 ... 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Universal Electronics CONTROL 2 Guide de l'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Télécommandes Universal Electronics CONTROL 2