Universal Electronics TIME WARNER CABLE Guide de l'utilisateur télécharger pdf (Page 15)

RE-ASSIGNING DEVICE KEYS

The URC-1047 Universal Remote Control can be set up to

control a second TV, PVR, DVD player, or VCR, or any

combination of up to four home entertainment devices.

For example, to have the unit control a TV, a Cable Con-

verter, and two VCRs, you will need to re-assign the

unused AUD key to operate the second VCR as follows:

1. On the remote control,press VCR once.

Then press and hold SETUP until the

VCR key blinks twice,then release SETUP.

2. Enter 9 - 9 - 2.The VCR key will blink twice.

3. Press VCR once, then press AUD once. The

AUD key will blink twice.

4. The AUD key is now ready to be programmed

for your second VCR. See Programming Device

Control on page 8.

To re-assign other device keys, repeat steps 1 to 4 and

substitute the key sequence using the following chart:

To Re-Assign Perform Key Sequence

TV as 2nd VCR key: TV - SETUP - 9 - 9 - 2 - VCR - TV

TV as 2nd AUD key: TV - SETUP - 9 - 9 - 2 - AUD - TV

TV back to TV: TV - SETUP - 9 - 9 - 2 - TV - TV

VCR as 2nd TV key: VCR - SETUP - 9 - 9 - 2 - TV - VCR

VCR as 2nd AUD key: VCR - SETUP -9 - 9 -2- AUD - VCR

VCR back to VCR: VCR - SETUP -9 - 9 -2 - VCR - VCR

AUD as 2nd TV key: AUD - SETUP - 9 - 9 - 2 - TV - AUD

AUD

back to

AUD

AUD - SETUP -9 - 9- 2 - AUD - AUD

Upon completion of a re-assignment, the selected mode

key will blink twice to confirm your selection.Then you’ll

need to program device control (see Programming Device

Control on page 8).

Time Warner Houston Manual 11/20/02 3:54 PM Page 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Pas de commentaire

Universal Electronics TIME WARNER CABLE Guide de l'utilisateur Page 15