Universal Electronics TIME WARNER CABLE Guide de l'utilisateur télécharger pdf (Page 16)

CHANGING VOLUME LOCK

On the URC-1047 Universal Remote Control,Global

Volu m e Lo ck is set to TV,so you can control TV volume

while in the TV, VCR, or Cable mode.If desired, you can

still perform Individual Volume Unlock on a selected

device to set its volume control for independent operation.

NOTE: The audio mode’s volume controls are active regardless of

Volume Lock settings. However, if you lock the volume controls to

the AUD mode, you will have control of the audio device’s volume

in all other modes (i.e., TV , VCR,and CBL).

To Unlock Volume Control For A Single Device

(Individual Volume Unlock):

1. Assuming Global Volume Lock is active,select

a mode on the remote control that you want to

unlock (e.g.,CBL) and press it once.Next,

press and hold SETUP until the device key

blinks twice, then release SETUP.

2. Enter 9 - 9 - 3.The last-selected device key

will blink twice.

3. Press VOL– once.The selected device key will

blink four times.

4. Repeat steps 1 through 3 (of this section) for

each device you want volume to be unlocked.

5. Now,after you select a device that has volume

unlocked (e.g.,CBL), pressing VOL+, VOL–,or

MUTE, will control the device’s volume only in

its own mode.

To Unlock All Volume Control

(Global Volume Unlock):

NOTE: Performing these instructions will set independent volume

control for all programmed devices (e.g., TV volume control in

TV mode,VCR volume in VCR mode, etc.).

1. On the remote control,press and hold SETUP

until the last-selected device key blinks twice,

then release SETUP.

2. Enter 9 - 9 - 3. The last-selected device key

will blink twice.

3. Press VOL+ once.The last-selected device key

will blink four times.

Time Warner Houston Manual 11/20/02 3:54 PM Page 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Pas de commentaire

Universal Electronics TIME WARNER CABLE Guide de l'utilisateur Page 16