Universal Electronics OCAP 5 Manuel d'utilisateur télécharger pdf (Page 14)

www.urcsupport.com/atlasocap

5. To check for other device codes, repeat steps 1

through 4, but substitute the appropriate key

(e.g., VCR, DVD, AUD, or CBL) for the device

you are checking. Write down the codes in the

appropriate boxes on page 11.

PROGRAMMING CHANNEL CONTROL LOCK

By default, the remote control’s channel-control

capabilities are locked to the cable converter. The

affected keys

are 1 through 0, CH+, CH-, and LAST. This

will guarantee that you do not inadvertently change a

channel on your TV or VCR. However, you can de-

activate this feature to allow full access to these keys in

the TV and VCR modes.

NOTE: This feature does not affect the AUD mode.

Unlocking Channel Control

Now the remote control will provide TV and VCR

channel-control capabilities while in the TV or VCR

mode.

Locking Channel Control to CBL

4. Repeat step 3 three more times for the

remaining digits. Use 2 for the second digit, 3

for the third digit, and 4 for the fourth digit.

Finish writing down the code in the TV Code

boxes on page 11.

1. On the remote control, press CBL once; it will

blink once. Press and hold SETUP until the

CBL key blinks twice.

2. Enter 9 7 3. The CBL key will blink twice.

3. Press CH- once. The CBL key will blink four

times.

1. On the remote control, press CBL once; it will

blink once. Press and hold SETUP until the

CBL key blinks twice.

2. Enter 9 7 3.The CBL key will blink twice.

Atlas OCAP M1056.fm Page 14 Tuesday, March 24, 2009 4:45 PM

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Pas de commentaire

Universal Electronics OCAP 5 Manuel d'utilisateur Page 14